MIOX Controls
Control, monitor and diagnose performance.
Control Panel
Every MIOX system incorporates an embedded controller to monitor and control the functions of each electrolytic cell, achieving complete system operational redundancy. This is particularly important for multiple cell systems where regulatory or customer requirements dictate system redundancy.
The control panel reflects operating parameters including cell amperage and brine pump voltage. The controller also serves as a diagnostic tool to correct system issues. Standard controls include:
- cell purge on startup and shutdown to prevent electrical surges and to lengthen the life of the cell
- a slow ramp-up to the amperage set point to reduce hydrogen gas bubbling at startup and for gradual load addition
- high cell current protection
- brine pump overspeed alarms to provide maintenance notification before failure
- thermal switch on the power supply for an upset condition
- alarms for low voltage on primary and auxiliary power supplies
The standard control system incorporates an alarm output relay and a serial data port to provide comprehensive data output to a MIOX-supplied local control panel for the complete disinfection system, or to a plant SCADA system. The RIO series utilizes the Allen Bradley MicroLogix 1200 PLC. MIOX has extensive experience integrating these control systems into a variety of customer plant SCADA platforms.
Inside the System
that those that buy bottled water pay 1,000 times or more for water than those using EPA-approved tap water?